Owner`s manual

11
HOW AND WHEN TO USE THE
JUMPER
The keypad has a three-terminal jumper connected
to the positive (+) side of the
ARM
,
LOOP
, and
POWER
terminals. If your system uses a common
positive power supply for these three connections,
you can route a single wire from your alarm panel
and connect it to one terminal. The jumper bridges
power to the other two terminals.
If your system has a common positive connection
for the indicators, leave the jumper where it is and
make connections similar to the drawing below.
Illustration: Connection positive common.
49-537.fm Page 11 Thursday, August 19, 1999 9:16 AM