Owner`s manual

9
Set-up
3. Enter the phone number (up to 16 dig-
its).
If you make a mistake while entering the
number, press
STORE
then begin again
from Step 2.
4. Press
STORE
. The dialer sounds a 1-
second beep.
5. Repeat Steps 1–4 to enter more num-
bers.
Notes:
• If you try to store more than 16 digits,
the dialer beeps 4 times and does not
store the number.
• If you use the dialer on a phone system
that requires you to dial an access code
for an outside line, you should program
a pause after the access code to allow
time for the outside line to connect. To
program a 2-second pause between dig-
its, press
PLAY/PAUSE
at the point in the
dialing sequence where you need to
pause.
Pressing
PLAY/PAUSE
counts as one of
the 16 digits available in a memory loca-
tion.
To replace a number, simply store a new one
in its place.
To clear a number from memory, repeat
Steps 1, 2, and 4 only.
RECORDING AN OUTGOING
MESSAGE
Your outgoing message can be up to 20 sec-
onds long. Here is a typical outgoing mes-
sage:
“This is the John Doe residence at 812 Ma-
ple Street. If you heard five single tones at
the start of this message, our alarm is indi-
cating a fire. Notify the fire department. If you
heard five high-low tones at the start of this
message, our alarm is indicating a burglary.
Notify the police department.”
1. Press
RECORD
. The RECORD indicator
lights.
2. Speak clearly in a normal voice about 12
inches away from the microphone on the
front of the dialer.
The RECORD indicator turns off after 20
seconds.
3. If you finish your message before the
RECORD indicator turns off, press
RECORD
to stop recording.
You can hear the outgoing message by set-
ting
MONITOR
to
IN
, then pressing
PLAY/
PAUSE
. To stop playback before the mes-
sage ends, press
PLAY/PAUSE
again.
SELECTING THE NUMBER
OF DIAL ATTEMPTS
The dialer is preset to call each stored num-
ber once. However, you can set the dialer so
it calls each number up to three times until a
call to that number has been answered.
To change the currently set number of dial
attempts, pull up on the dialer’s cover, press
TEST
, then press
0
.
The dialer sounds a tone when you have set
it to call three times. The dialer does not
sound a tone when you set it to call only one
time.
TESTING THE DIALER
You can test the dialer to make sure it cor-
rectly dials the numbers and plays the outgo-
ing message.