User`s guide

37
The remote station must be set to INTERCOM HANDSFREE. When you call this
phone on the intercom, its speakerphone activates and remains on, allowing you
to hear sounds in that room until you hang up.
To prevent sounds in your room from being transmitted to the room you are moni-
toring, you must press MUTE on your phone.
7.8 Naming Stations
At Station #11:
1 Press PROGRAM NEXT
Enter code: *718.
2 Press the soft key under NEXT
repeatedly, until "
SSttaattiioonn NNaammiinngg
"
appears in the display, and then
press ENTER.
- The display will show the currently
stored name for station #11, or
indicate "
NNoo NNaammee
" if no name has
yet been given to station #11.
3 Press the soft key under CHANGE if you wish to store a new name for
station #11, or press NEXT repeatedly until you see the station number
that you want to name, and then press CHANGE.
4 Use the dialpad numbers to enter the name for the desired station.
5 Press the soft key under SAVE.
Repeat steps 1-5 for any additional stations you wish to name.
If you wish, you may give a name to each of your EP4300 telephones, so that peo-
ple can see the names along with the station numbers when they place intercom
calls. For example, you might name station #12 "Mary" and station #15
"Conference Room."
Your EP4300 system can accomodate up to 16 stations. The maximum number of
lines will depend on how you choose to install the system.
Note: If your station is not #11, you just can see the name along with the station.
Intercom Operation