User`s guide

Installing Your System
3
3.5 Setting User PIN
 To Enter User Mode
1 Press PROGRAM button.
2 Press the soft key under NEXT, then “
EEnntteerr CCooddee::
” appears in the display.
3 To enter User mode, simply enter the User password.
- The default User password is *718.
Note: If in case that the Toll restriction access code password is forgotten, please
contact your local dealer or the support centre, for master reset. This will bring the
passwords back to 1234.
3.6 V
erifying Proper Installation
The following procedure should be used at each telephone to verify proper instal-
lation. Also use this procedure any time you are experiencing difficulty, to test sys-
tem configuration and identify possible system connection errors. The phone must
be connected to the AC power supply, line 1 must be connected to the line 1 jack,
and the phone must have been assigned an intercom station number.
First, verify that line 1 is connected to the same telephone number at all the tele-
phones. To do this, press the line 1 button at one of the telephones. The line 1 LED
should be green, the speakerphone LED should be red, and dial tone should be
heard from the speaker. Now go to each of the other stations and make sure that
each line 1 LED is red.
Next, make sure that lines 2, 3 and 4 are connected the same at all the phones by
following the following steps at each telephone:
1. Press the line 1 button. The line 1 LED should be green, the speakerphone LED
should be red, and dial tone should be heard from the speaker.
2. Dial the telephone number for line 2. The line 2 LED should flash slowly. If the
line 2 LED does not flash, then line 2 is improperly connected to this telephone.
3. If this telephone utilizes line 3 and/or line 4, repeat steps 1 and 2, substituting
the respective phone number(s) in step 2.