Owner`s manual

SPECIFICATIONS

Sampling Rates ......................................... 50, 100 ns

.5, 1, 5, 10, 50 ms

.1, .5, 1 ms

DC Band Width ....................................... DC – 5 MHz

AC Band Width ................................ 100 Hz – 5 MHz

A/D Converter .................................... 6-Bit resolution

RAM ........................................................... 128 Bytes

Input Coupling .................. AC, DC, or GND (Ground)

Input Voltage Ranges ........................... 1V, 10V, 100V

Note

: All voltages measurements are referenced to 0V

ground. The effective ranges for AC volt measure-

ments in DVM mode are 0.33V, 3.3V, and 33V since

the peak-to-peak voltage must be digitized and con-

verted to the RMS value.

Trigger Definitions .................. Auto, Internal, External

Trigger Levels ............................ Six selectable levels

Note

: Level tolerances are dependent on the selected

input voltage range: 1V ±.1V, 10V ±3V, 100V ±10V

Trigger Modes ......... Continuous RUN/SINGLE Cycle

Display ....... 16 ¥ 32 dots resolution, LED backlighted

Serial Line ............................................ 19.200 kBaud

7 Data Bits, 1 Stop Bit, No Parity

DVM Accuracy ............................................±2 to ±5%

(depending on the parameter settings)

Power Supply ............................................9 – 13V DC

red (+) and black (–) alligator clips

Current Required ........ Backlight Off = 12 mA Typical

Backlight On = 85 mA Typical

22-310.fm Page 52 Friday, August 6, 1999 12:26 PM