Owner`s manual

46
13. Apply the probe tip to the signal source to be
measured.
14. Turn on the device to be measured. A single
waveform appears on the oscilloscope screen.
15. Measure the single sweep frequency as follows:
a.Place the mouse cursor directly over the oscillo-
scope screen’s left vertical cursor. The cursor’s
shape changes to a cross.
b.While you press and hold the left mouse button,
move the mouse left or right until the screen’s
left vertical cursor touches the point where the
rising edge of the waveform intersects the zero
reference line.
c.Place the computer’s mouse cursor directly over
the oscilloscope screen’s right vertical cursor.
The cursor’s shape changes to a cross.
Left Cursor
Right Cursor
22-310.fm Page 46 Friday, August 6, 1999 12:26 PM