Owner`s manual

14
CONNECTING THE EXTERNAL
INPUTS
1. Connect the supplied white signal wire’s plug into
the
GROUND (0 Volt)
jack.
2. If you are using an external trigger source, con-
nect the supplied gray trigger wire’s plug into the
EXT. TRIGGER
jack.
Caution
: If you are not going to use an external
trigger source, do not connect the gray trigger
wire to the ProbeScope.
Ground (0 Volt)
Ext.Trigger
Gray Wire
White Wire
To the 9-Pin
Female Connector
To the Power Source
22-310.fm Page 14 Friday, August 6, 1999 12:26 PM