User`s guide

13
Scanner Setup
Note: If you entered an invalid bank or
channel number,
Error appears and the
scanner beeps. Enter a valid channel.
5. Use the number keys to enter the frequency,
using • for the decimal point.
6. Press ENT/PGM to store the frequency into
the channel.
7. To program the next channel in sequence,
press S or T and repeat Steps 5 and 6.
Notes:
• If you entered an invalid frequency in Step 5,
E
rror appears and the scanner beeps. Enter
a valid frequency.
• If you entered a frequency in Step 5 that
already exists on another channel, the
scanner beeps and displays that channel.
Press CL to clear the display, or press
ENT/PGM to store the frequency in both
channels.
• The scanner automatically rounds the
entered number to the nearest valid
frequency. For example, if you enter 151.473
(MHz), your scanner accepts it as 151.475.
• After a transmission, the scanner
automatically pauses for 2 seconds on this
channel before proceeding to the next
active transmission. Press •/DELAY to turn
the delay function on or off. The scanner
stores this setting in the channel.
If you do not have a list of frequencies in your
area, use a limit search, fine tune, or service
search to find transmissions. A good online
resource is www.radioreference.com.