Owner`s manual

PRIORITY
To program a 2-second delay for any
active frequency while searching,
press DELAY until DELAY appears on
the display. When your scanner stops
on a frequency, it waits for 2 seconds
after each transmission before it re-
sumes searching.
To turn off the programmed delay on
any active channel, press DELAY
while the channel is still active. DE-
LAY disappears from the display.
LOCKING OUT A
CHANNEL
You can scan channels faster by lock-
ing out those that have a continuous
transmission, such as a weather
channel.
To lock out a channel while scanning,
press LOCK OUT when the scanner
stops on the channel. To lock out a
channel manually, manually select the
channel and press LOCK OUT until
LOCK-OUT appears on the display.
To remove the lockout from a chan-
nel, manually select the channel and
press LOCK OUT so LOCK-OUT dis-
appears from the display.
Notes:
• You can still manually select
locked-out channels.
• You cannot lock out all channels.
There must be at least one active
channel in a bank.
The priority feature lets you scan
through the programmed channels
and still not miss an important or in-
teresting call on a specific channel. To
program a stored channel as the pri-
ority channel, press PROGRAM, the
desired channel number, and then
PRIORITY.
Note: You can only select one chan-
nel as the priority channel.
To turn on the priority feature, press
PRIORITY during scanning. PRIOR-
ITY appears on the display. The
scanner checks the priority channel
every 2 seconds, and stays on the
channel if there is activity. P appears
to the left of the display whenever the
scanner is set to the priority channel.
To turn off the priority feature, press
PRIORITY during scanning until PRI-
ORITY disappears from the display.
19