Owner`s manual

Priority Channel — lets you set the scanner to check one channel every 2

seconds so you do not miss transmissions.

Data Cloning — lets you transfer the programmed data to another PSR-200/

100 scanner.

Liquid-Crystal Display — makes it easy to view and change programming

information.

Supplied Telescoping Antenna — provides good reception of strong local

signals.

External Antenna Connector — lets you connect an external antenna (not

supplied) with a BNC connector to the scanner for improved reception of dis-

tant/weaker signals.

Your PSR-200 scanner can receive these bands:

Frequency Range (MHz) Types of Transmissions

29–54 10-Meter Ham, VHF Lo, 6-Meter Ham

108–136.9875 Aircraft

137–174 Military Land Mobile, 2-Meter Ham, VHF Hi

380–512 UHF Aircraft, Federal Government, 70-cm Ham,

UHF Standard, UHF “T”

Note: See “Specifications” on Page 28 for more information about the scanner’s

frequency steps.

THE FCC WANTS YOU TO KNOW

This equipment has been tested and found to comply with the limits for a scan-

ning receiver, pursuant to Part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or televi-

sion reception, which can be determined by turning the equipment off and on,

the user is encouraged to try to correct the interference by one or more of the

following measures: