Owner`s manual

Cloning the Programmed Data

You can transfer the programmed data to and from another PSR-200 (or PSR-

100) scanner using an optional connecting cable with 1/8-inch (3.5mm) stereo

(TRS) phone plugs on both ends (not supplied).

1. Turn on both scanner.

2. Connect the connecting cable to each scanner’s PC/IF jack. CLOnE and

UP to SEnd appears.

3. Press at the host scanner.

4. SEndInG appears at the host scanner.

The scanner sends the data. To exit the clone mode, remove the cable.

CLOnE and Error may alternately appear when the scanner receives data from

a scanner other than a PSR-100/200. If this happens when the scanner re-

ceives data from another PSR-100/200, turn off the scanner and then turn it on

again.

INITIALIZING THE SCANNER

If the scanner’s display locks up or does not work properly after you connect a

power source, you might need to initialize the scanner.

1. Turn off the scanner, then turn it on again. WELCOME SCAnnInG rECEIVEr

appears.

2. Press 0 while Welcome message appears. Then press 1. InItIAL appears

about 2 seconds. After 2 seconds, YES —Ent and No —CLEAr appears

alternately.

3. Press ENT. WAIt appears for about 2 seconds.

Note: Do not turn off the scanner until the initialization is complete. When the

initialization is complete, 1CH 000.0000 appears on the display.

Important: This procedure clears all information you stored in the scanner’s

memory. Initialize the scanner only when you are sure the scanner is not

working properly.