Owner`s manual

Locking Out Marine Channels

To lock out a Marine channel during searching, press L/O when the scanner

stops on the channel.

To manually lock out a Marine channel, select the channel then press L/O.

To remove the lockout from a Marine channel, manually select that channel

again, then press L/O until disappears.

Locking Out Frequencies

To lock out a frequency during a one-touch service search, press L/O/L/O RVW

when the scanner stops on that frequency. The scanner locks out the frequency

then continues searching.

Note: You can lock out as many as 50 frequencies during a search. If you try to

lock out more, FLo -FULL appears (see “Reviewing Locked-Out Frequencies”

and “Removing Lockouts From All Frequencies in a One-Touch Service Search

Band”).

Reviewing Locked-Out Frequencies

To review the frequencies you locked out, hold down L/O for about 2 seconds

during a search, then repeatedly press or . L-r (Lockout Review) appears

and the scanner displays all locked out frequencies as you press or , or,

EMPty appears when the search bank has no locked out frequencies. When

you reach the highest locked-out frequency, the scanner beeps twice and re-

turns to the lowest locked-out frequency.

Removing Lockouts Form All Frequencies in a One-Touch

Service Search Band

Note: These steps do not clear any lockouts in the marine and weather band.

1. Hold down L/O/L/O RVW for about 2 seconds during a desired search band.

L-r appears.

2. While holding down TUNE/CLEAR, press L/O to clear the lockout. FLo ALL-

CL appears about 2 seconds. After 2 seconds, YES —Ent and No —CLEAr

appears alternately.

3. Press ENT. L-r EMPty appears. The scanner clears any lockouts from all

frequencies in a one-touch service search band. Or, if you do not want to

clear the lockouts, press TUNE/CLEAR.