Owner`s manual

17
Note: If you entered a frequency that is already stored in another channel, the
lowest numbered channel containing the duplicate frequency and -dUPL- (du-
plicate) flash for about 3 seconds. If you want to store the frequency anyway,
press ENT again. You can then delete the frequency later. See “Clearing a
Stored Channel” on Page 19.
If there is no empty channel in the bank, Ch-FULL appears after you press
ENT. To store more frequencies, you must clear some channels or you may
program the other bank. See “Clearing a Stored Channel” on Page 19. To con-
tinue searching after Ch-FULL appears, press TUNE/CLEAR.
Using Tune
During a tune, the scanner tunes up or down, starting from a frequency you
specify. Follow these steps to use tune.
Note: You can use the scanner’s delay feature while using tune.
1. Press TUNE. PSE and start frequency appears.
2. If desired you can change the start frequency. To change the start frequency,
enter frequency with numeral keys, then press ENT.
3. Press PSE to start tune. -t- appears on the display.
4. To change the tuning direction, press or . The scanner displays or
and start tune.
Note: To pause the tune, press PSE. To resume tune, press PSE again.
5. To tune for another active frequency, press or .
Once you find interesting frequencies during the tune, you can store them into
the scanner’s channel-storage banks.
1. To store the displayed frequency in the desired bank’s lowest vacant chan-
nel, press ENT when you find a frequency. The bank number and StorE
appears.
2. If you desired to store the other bank, press number key.
3. Press ENT to store the frequency. The channel and frequency flash twice. If
you want to cancel the operation, press TUNE/CLEAR instead of ENT.
Note: If the scanner displays -dUPL-, the entered frequency is already stored
in another channel. See above Note on this page.
If there is no empty channel in the bank, Ch-FULL appears after you press
ENT. To store more frequencies, you must clear some channels or you may
program the other bank.