User`s guide

3. Press MAN.

4. Press FUNC, then press /BANK or (Press FUNC, then press ) to advance the

channel with 0 MHz in next bank (or previous bank).

• If the channel with 0MHz is not, the first channel of the bank is selected.

• If you entered an in valid channel number, “Invalid Channel.” Appear. appears and the

scanner beeps error tones. Enter a valid channel.

5. Use the number keys and •/DELAY to enter the frequency, including the decimal point

you want to store.

6. Press ENT/PGM to store the frequency into the channel.

Notes:

• If you entered an invalid frequency in Step 5, “Invalid Freq.” appears and the scanner

beeps error tones. Enter a valid frequency.

• If you entered a frequency in Step 5, which already exists on another channel, the

scanner beeps an error tone and displays that channel. Press CL to clear the display, or

press ENT/PGM to store the frequency in both channels.

• The scanner automatically rounds the entered number to the nearest valid frequency.

For example, if you enter 151.473 (MHz), your scanner accepts it as 151.475.

• After a transmission, the scanner automatically pauses for 2 seconds on this channel

before proceeding to the next active transmission. Press •/DELAY to turn the delay

function off or on. See “delay”). The scanner stores this setting in the channel.

7. To program the next channel in sequence, press or and repeat Steps 5 and 6.

Programming channels text tag

You can customize your scanner by storing text tags (up to 16 characters) for easy

identification of channel.

1. Press ENT/PGM to put the scanner in programming mode.

2. Enter the channel number where you want to store a text tag. If you make a mistake,

press CL repeatedly until the display is cleared.

3. Press MAN to advance the channel.

4. Press TEXT to put the scanner in program channel text tag edit mode. The cursor

appears.

5. Press ?or ? to move the cursor in the right or the left. Press the number key and

decimal key to enter the letter. (See “text input chart”).

6. Input the word (Public Ch) and press ENT/PGM to store.

Programming bank text tag

You can customize your scanner by storing text tags (up to 16 characters) for easy

identification of bank.

1. Press ENT/PGM to put the scanner in programming channel mode.

2. Enter the channel number where you want to store a text tag. If you make a mistake,

press CL repeatedly until the display is cleared.

3. Press MAN to advance the channel.

4. Press FUNC, and then press TEXT to put the scanner in program bank text tag edit

mode. The cursor appears.