User`s guide

0 S4 S0 S4 S0 S3 S4 S4 S3

1 S4 S0 S0 S0 S3 S3 S4 S10

2 S0 S0 S0 S0 S11 S10 S4 S10

3 S0 S0 S0 S0 S4 S4 S11 S11

4 S0 S0 S0 S0 S4 S4 S11 S0

5 S0 S0 S0 S0 S0 S4 S0 S0

6 S0 S4 S0 S0 S0 S12 S12 S12

7 S0 S4 S0 S4 S0 (S12) (S12) (S12)

selecting a preset fleet map

1. Press FUNC, then press MENU to open menu mode.

2. Select the “Trunk Option” - “Select Bank” - “Select Trunk Sys”.

3. Repeatedly press or to select MOT 800 or MOT 800 CUSTOM system, and press

ENT/PGM.

4. Repeatedly press or to select Edit Fleet Map, and press ENT/PGM.

5. Repeatedly press or to select the preset map, and press ENT/PGM.

6. Repeatedly press or to select the name of the desired map (example E1P7), and

press ENT/PGM. Then the scanner returns to previous screen.

Note: When the scanner searches for transmissions, Type I fleet and subfleet IDs such as

100-12, 100-9, 000-12, or 400-8 display.

If you are still unable to listen to a complete conversation, then try another preset map.

programming a fleet map

1. Press FUNC, then press MENU to open menu mode.

2. Select the “Trunk Option” - “Select Bank” - “Select Trunk Sys”.

3. Repeatedly press or to select MOT 800 or MOT 800 CUSTOM system, and press

ENT/PGM.

4. Repeatedly press or to select Edit Fleet Map, and press ENT/PGM.

5. Repeatedly press or to select the custom map, and press ENT/PGM.

6. Repeatedly press or to select the size code for first block, and press ENT/PGM.

Then the next available block appear. For specifics about each size code, see preset fleet maps

table.

7. Press SCAN in open mode. If the scanner ‘s setting is close mode, press FUNC, then

•/DELAY/OPEN/CLOSE to switch open mode from close mode. The scanner exits the

trunking programming mode, tunes the data channel, and then searches using the map you

programmed.

Note: If you select size code S-12, S-13, or S-14, these restrictions apply:

• S-12 can only be assigned to Blocks 0, 2, 4, or 6

• S-13 can only be assigned to Blocks 0 and 4

• S-14 can only be assigned to Block 0

Since these size codes require multiple blocks, you will be prompted for the next available

block when you program a fleet map. For example, if you assign Block 0 as S-12, the

scanner prompts you for b2, the next block available, instead of b1. If you assign Block 0 as