User`s guide

21
4. Press or to select the next channel in the bank.
5. Repeat from step 2 until you enter all the desired frequencies in that bank.
Notes:
• If you enter an invalid frequency (outside the selected range), the scanner beeps, then
Invalid Freq. appears. If this happens, press CL to clear the frequency, and then repeat the
entry.
• For EDACS (Ed) and LTR systems, you must enter the frequencies in logical channel
number (LCN) order.
• If you try to enter a duplicate frequency, the scanner beeps and the channel which was
previously stored appears
6. Press SCAN to begin scanning for the trunk’s data channel and scan conventional
frequencies at the same time. As the scanner looks through the frequencies, you see them
on the display. When the scanner finds the controlling data channel, the scanner begins
trunking.
programming trunked banks
Follow these steps to select and program trunk bank mode.
1. Press TRUNK in conventional programming mode to go to Program Trunk Bank Mode
2. Press or to select the desired trunked system.
Note: List of trunked systems as follows:
You See Trunk System
MOT 800 Motorola
Type I, Type II and Hybrid
800 MHz frequencies
MOT 800 CUSTOM Motorola
Type I, Type II and Hybrid
800 MHz frequencies Custom
MOT 900 Motorola
Type II,
900 MHz frequencies
MOT VHF Motorola
Type II,
VHF(136-174 MHz) frequencies
MOT UHF Motorola
Type II,
UHF (406-512 MHz) frequencies
EDCS EDACS Wide Band: 9600 baud
EDCS SCT EDACS Scat
LT LTR
NON TRUNK No Trunk
Notes:
• MOT 800 CUSTOM, MOT VHF, MOT UHF require programming of a Base, Spacing