User`s guide

You can lock out the log channels like normal channels.

Set Logging to ON to scan the log channels along with the normal channels. If you do not

want to scan the channels, set it to OFF.

The scanner stores signals found by the Signal Stalker I even the Logging function is OFF.

The frequencies in the log channels are deleted when the scanner is turned off.

3. Repeatedly press or to select the option you want, then press ENT/PGM.

• Band Switch: If you selected Band Switch, one of the following band names appears:

25-54 : VHF Low Band

108-137: AIR Band

137-174: VHF High Band 1

216-320: VHF High Band 2

400-512: UHF Band

764-956: 800MHz Band

Repeatedly press or to select the band you want to set, then press ENT/PGM.

4. Repeatedly press or to select ON or OFF, then press ENT/PGM.

5. When you select the option, press CL to exit the option mode.

6. Press MENU to exit the menu mode.

band meter for Signal Stalker

This meter allows you to see which band Signal Stalker is searching for. When a strong and

consistent signal is detected, this meter will rise up to Max. And the scanner is tuned to the

signal and shows up the band where the signal is detected.

However, there is a case that the scanner might not be able to catch the signal even if this

meter rises to MAX. It is because the signal might be out of range, it might be a locked out

frequency, or it might be a signal screened common pager frequency as the pager signal. If

you want to improve the performance when signal stalker is On (not in "ONLY Mode" ),

disable the band (see xx).

Note: This feature is different from so-called SIGNAL STRENGTH METER using RSSI.

using Signal Stalker I

Note: Turn off the data skip feature if it is on.

To turn on Signal Stalker I, turn SQUELCH fully clockwise, and then press except in

WX search, program search range, or program mode. appears. Every 2 seconds, the

scanner searches for frequencies in the range you specified in “Setting the Signal Stalker I

Options.”