User`s guide

14
PRO-162 to another PRO-162 or PRO-433 using an optional interface cable and software.
1. Make sure the scanners are turned off and then plug the cable into each scanner’s PC/IF
jack.
2. Turn on both scanners. “Clone Mode [ENT] to send” appears.
3. Press ENT. Then “Confirm Send Data? [1] to Yes [CL] to No” appears.
4. Press 1 to send the data to the other unit or press CL key to cancel the operation.
5. When the data transfer is completed, “Clone Mode Finished” appears. If the data transfer
is not successful, “Clone Mode Error” appears.
6. After the clone operation is complete, remove the cable, turn both unit off and then on
again.
using the display backlight
To turn on the display light for easy viewing at night, press .The display lights for 15
seconds.
using the auto backlight display
You can set the scanner so the auto backlight turns on for about 5 seconds when the
scanner receives signals.
If you press a key (except) within 5 seconds, the display remains lighted for more than 15
seconds.
To turn auto backlight display on or off:
1. Press FUNC, and then press MAN/MENU.
2. Repeatedly press or to select Back Light, then press ENT/PGM.
3. Repeatedly press or to select Auto Light, then press ENT/PGM.
3. Repeatedly press or to select ON or OFF, then press ENT/PGM.
4. Press L/O to exit the menu mode, or press CL to back to a previous menu.
using LCD contrast
You can change LCD Contrast you want.
To change LCD Contrast on your scanner:
1. Press FUNC, and then press MAN/MENU.
2. Repeatedly press or to select LCD Contrast, then press ENT/PGM.
3. Repeatedly press or to select contrast level you want. There are 8 steps as Contrast
1-8.
4. Press MAN to exit the menu mode.
search speeds
Note: Hypersearch applies only to the 5 kHz step bands (25–54 MHz, 137–174 MHz, and
216–224.9950 MHz).
The scanner has two search speeds.
Normal Search (90 steps/second)
Hypersearch (270 steps/second)
turning the keytone off/on
Each time you press any of the scanner’s keys, the scanner sounds a tone. To turn the