User`s guide

47
Trunk Scanning
Notes:
You can scan only one type of trunked
frequency, either EDACS (GE/Ericsson),
Motorola, LTR (EF Johnson), or EDCAS SCAT
in a bank at one time. You can, however, mix
conventional channels and frequencies in a
bank.
If you are programming trunked frequencies
for Motorola Type I and hybrid systems, you
must first program the fleet map (see “Type I
and Hybrid Trunked Systems” on p. 62).
If you are programming frequencies for an
EDACS system you must store them in the
Logical Channel Number order (usually listed
as LCN#). For example, LCN1 would go into
channel 01 for the current bank, and LCN2
would go into channel 02.
If you are programming frequencies for an
LTR system you must store them in the home
repeater order. For example, home repeater
order 1 would go into channel 01 for the
current bank, and home repeater order 2
would go into channel 02
Follow these steps to program trunked
frequencies:
1. From Scan or Manual Mode, press ENT/PGM
to put the scanner in Programming Mode.
2. Press FUNC + T or S to select a bank. Hold
down T or S to move through the bank
selection faster.
3. Press T or S to select a channel. Hold
down T or S to move through the channel
selection faster.
4. Press TRUNK/MODE to enter the Trunk ID
Programming Mode.