User`s guide

17
Scanner Setup
“Erase Frequency” will appear; press ENT/PGM
to erase.
• The scanner automatically rounds the
entered number to the nearest valid
frequency. For example, if you enter 151.473
(MHz), your scanner accepts it as 151.475.
• After a transmission, the scanner
automatically pauses for 2 seconds on this
channel before proceeding to the next
active transmission. Press •/DELAY to turn
the delay function on or off. The scanner
stores this setting in the channel.
• To store trunked system frequencies, see
“Programming Trunked Frequencies” on p. 46.
If you do not have a list of frequencies in your
area, use a chain, fine tune, or service search to
find a transmission (see “Searching” on p. 21). Also
refer to www.radioreference.com.
Entering Channel Text Tags
To store text tags for easy identification of channels:
1. From Manual Mode, press ENT/PGM to put
the scanner in Programming Mode.
2. Enter the channel number where you want to
store a text tag. If you make a mistake, press
CL repeatedly until the display is cleared.
3. Press MAN/MENU.
4. Press PSE/TEXT to put the scanner into
channel Text Tag Mode. The cursor appears.