User`s guide

16
Scanner Setup
Manual Mode
To enter Manual Mode from any other mode,
press MAN/MENU.
Programming Frequencies into
Channels
Before the scanner can begin to scan, you must
program a frequency into at least one channel.
To locate and store specific frequencies into
channels for later use:
1. From Manual Mode, press ENT/PGM to put
the scanner in Programming Mode.
2. Press FUNC + S or T to select a bank.
3. Press S or T to select a channel
4. Use the number keys to enter the frequency,
using • for the decimal point.
5. Press ENT/PGM to store the frequency into
the channel.
6. To program the next channel in sequence, press
S or ENT/PGM and repeat Steps 4 and 5.
Programming Notes:
• If you entered an invalid frequency in Step 5,
“Invalid Freq.” appears and the scanner beeps
error tones. Enter a valid frequency.
• If you entered a frequency in Step 5, which
already exists on another channel, the
scanner beeps an error tone and displays
that channel. Press CL to clear the display,
or press ENT/PGM to store the frequency in
both channels.
• To erase a frequency from a channel, from
Manual Mode press ENT/PGM to enter
Programming Mode and then press CL.