User`s guide

13
Scanner Setup
jack. You can use an “Adaptaplug C” for AC
adapters. Using an adapter that does not meet
these specifications could damage the scanner or
the adapter.
To use an external power source:
1. Always connect the adapter
(not supplied) to the scanner
first.
2. Plug the adapter into the
power source.
3. To disconnect, unplug the
adapter from the power
source first.
Warning:
Do not connect a charging
adapter to the scanner if non-
rechargeable batteries (such as
alkaline batteries) are installed in
the scanner and the switch is set
to Ni-MH, or if you are unsure of
the switch’s position.
Turning on the Scanner
1. Turn SQUELCH fully counterclockwise.
2. Turn VOLUME/OFF clockwise until it clicks
and you hear a hissing sound.
3. Turn SQUELCH clockwise until the hissing
stops.
Note: Make sure the scanner’s antenna is
connected before you turn it on.
To perform a quick check of scanner operation,
press the WX / key. If you are near a NOAA
weather station, you should hear weather
information.
POWER
DC 9V