User`s guide

Scanner Setup

3. Insert two AA batteries (not included) into the

battery compartment and two AA batteries

into the battery compartment cover, matching

the polarity symbols (+ and -) marked inside.

4. Replace the cover.

Warning: Only set the

Battery Switch to Ni-MH

for use with nickel metal hydride

(Ni-MH) rechargeable batteries.

Never use non-rechargeable

batteries when the switch is set to Ni-MH.

To charge batteries:

1. Set the Power Switch to Ni-MH.

2. Install rechargeable batteries.

3. Connect an external power source to the

DC 9V 300mA jack.

The scanner stops charging automatically after a

maximum of 14 hours.

Warning: Do not attempt to charge batteries

if non-rechargeable batteries are installed in

the scanner and the switch is set to Ni-MH, or

if you are unsure of the switch’s position. Non-

rechargeable batteries will get hot and can explode if

you try to recharge them.

Battery Switch