Service manual

5
Notify Fletcher-Terry if there is any belt damage, pulley misalignment, or extreme
looseness of any of the pulleys or set screws.
One motor pulley set screw must be perpendicular to flat surface of the motor shaft.
Motor Belt Replacement and Tensioning
1) Remove the appropriate motor housing(s), as above.
2) Loosen, but do not
remove the four motor
mounting bolts, as
shown. (You will need a
3/8” wrench/socket and a
5/32” Allen wrench.)
Loosen the nuts/bolts no
more than 1 - 2 turns.
3) Move the motor on the
mounting plate slide
holes toward the large
pulley in order to create
slack in the belt. Remove
the belt from both pulleys
(unless the belt has failed
during use and already
fallen off).