Service manual

4) Carefully lift the power supply off the fixed mounting bolts by lifting upward on the

carry handles, then rearward, away from the machine frame. Use care to avoid the

cables and pneumatic hoses attached to the machine frame.

Set the power supply down onto the rubber pads behind the mounting plate surface.

5) Reverse the steps above to remount the power supply to the F-6100 frame.

Fuse Replacement: Replace blown fuse(s) with 4 Amp “slow-blow” type fuses,

available at Radio Shack or other electronic retailers.

Avoid

catching on

cables and

hoses

Caution! Do not attempt to remove the power supply housing from the

mounting plate, exposing the internal electrical components. Contact with

high-voltage capacitors may cause severe electric shocks, resulting in

serious injury or death. Repair of the power supply components should only

be attempted by an authorized electronics technician; no user-serviceable

com

onents are contained within the

ower su

enclosure.