Service manual

5) Tighten the mounting screws securely. Re-connect the wire terminals to the proper

limit switch tabs. Replace the bumper and spring onto the threaded post.

6) Turn on the machine, and press the Enable button. If the Enable light does not

remain on when released, double check the wire terminals and connections to this

switch, and to the other 3 limit switches as well. If the initial limit switch damage was

caused by a mat jamming behind the gantry during cutting, one or both of the limit

switch wires may have been damaged as well, or the Y home sensor mat be

misaligned*.

7) Make a test cut to ensure

that the cutting head /

gantry do not hit the limit

switch during homing

movement. Make sure that

the limit switch bracket is in

line with the Y-gantry

beam. There should be

~1/8” of clearance between

the limit switch roller and

bearing cart edge when it

is in the “Home” position.

(see photo)

8) If the machine is unable to “Home” properly without hitting a limit switch, you must

move the switch and mounting bracket downward slightly. Use a 5mm Allen wrench

to slightly loosen the limit switch bracket. Make sure that the bearing cart will actuate

the switch approximately 1/8” below the home position by pushing downward on the

head after a mat cut is completed.

* See X and Y Axis Home Sensor Replacement procedure

1/8” between switch roller and bearing cart at “Home”