Service manual

7) Make a test cut to verify that the borders are measuring accurately. It may be

necessary to move the sensor and/or magnet on the bracket slightly in order to

achieve the desired border accuracy (see below*). Minor calibration (<1/32”),

corrections may be made in Advanced Settings, Borders, Home X or Y Axis.

* These are the general guidelines for moving an X or Y axis home sensor to correct for

inaccurate border dimensions:

X- Axis (Horizontal) Border measures:

Too Small; Move sensor left (facing rear of machine)

Too Large; move sensor right ( “ “ “ “ )

Y- Axis (Vertical) Border measures:

Too small; move sensor bracket up, or magnet downward

Too large; move sensor bracket down, or magnet upward

Move the sensor or magnet by the exact amount of the border error; i.e. + or - 1/16”.

X-axis limit switch

X-axis Home sensor

Loosen bracket screw and move sensor left or right to adjust borders