Service manual

3) Disconnect the electrical

connector to the

appropriate Home Sensor

by pressing the locking

tabs inward as you pull the

connector blocks apart.

4) Remove the two small

mounting screws holding

the black (“Hamlin”),

home sensor to the

aluminum mounting

bracket. (3/32” Allen

wrench) Note the

orientation and location of

the sensor on the bracket

prior to removal.

5) Mount the new Home Sensor onto the bracket in as close to the same position as

the original as possible. Tighten both Allen screws securely.

6) Reconnect the wire connector, and tie the wires neatly to the nylon mounting block

with new zip ties. Make sure that the connector and wire are not in the path of the

cutting head/Y-axis bearing cart.