Service manual

Enable LED and Switch Replacement

(Enable Switch Assembly: part # 12-860; Enable LED bulb: #12-862)

Perform steps 1 – 3 as above.

4) Using a small flat blade screwdriver, carefully pry the lower plastic retaining tab from

the rear of the gray switch relay block, as shown. Then pry the top tab away from the

switch, and pull the relay block away. Note the orientation of which wire terminals

are located towards the top and bottom of the switch relay block. (Enable # 13 and

# 23 are at top)

5) To replace the LED bulb, simply

rotate the bulb counter-clockwise

~45 degrees, and pull out. Insert

the replacement LED, and push

inward and rotate 45 degrees

clockwise. Snap the relay block

back onto the switch, and replace

the switch panel and screws.