Service manual

6) Push the replacement Power switch through the panel, making sure that the “I”

symbol embossed onto the rocker switch is in the upper position, and the “0” is

toward the bottom. (see photo) The white printed area of the switch block should

also be facing left.

7) Re-connect the wire terminals to the proper tabs on the rear of the switch block.

Make sure that the tabs are inserted fully into the terminal connectors.

8) Pivot the switch panel back up into its normal position, and re-insert the four

mounting screws.

9) Plug the power cord back in, and turn the power switch on. Power should be ON

when the top portion of the switch is depressed, and the rocker switch should be

lighted. Replace the top access panel if the switch functions normally, and tighten all

access panel screws.