Service manual

3
5) Mount the replacement driver onto
the mounting plate, making sure
that it is oriented properly. Insert
and tighten all 4 mounting screws
with the Allen wrench. Plug both
front and rear green plugs back
into the new driver assembly.
6) Plug the main power cord back in,
and turn on power to the machine.
Enable the system, and attempt to
make a test cut. If the machine is
still inoperable, Check the fuses
on the underside of the main
power supply enclosure on the
rear of the machine. (See Power
Supply replacement procedure).
Replace blown fuse(s) with 4 Amp
“slow-blow” type fuses, available
at Radio Shack or other electronic
retailers as required.
If the machine operates normally, replace the top access panel on the electronics
enclosure.
1432
ON
C-Axis Driver Switch Locations
1432
Switch Locations
X and Y Axis
ON