Service manual

6) Set the transition board and

mounting plate assembly down on

a suitable work surface, and

remove the four Philips screws.

Transfer the new transition board

to the mounting plate, placing a

plastic spacer between the board

and plate at each corner.

7) Place the transition board and

plate back into the enclosure, and

tighten the four mounting plate

Allen screws.

8) Connect all of the cables back to the appropriate sockets. Carefully insert the ribbon

cable plugs into their sockets by pushing each side of the plug in alternately until you

hear an audible click when the locking tab snaps inward. Do NOT attempt to fold the

tabs up before the cable plug is fully seated in the socket.

9) Turn on the power and check for proper operation of the system. Replace the

electronics enclosure access panels.