Service manual

10
4) Loosen the 4 Allen screws (2-
front, 2-rear) on the transition
board mounting plate. Hinge
open the left side (from the
rear), of the rear enclosure
panel to allow access to the
rear plate screws.
Note: Removal of the
transition board by removing
the four Philips screws is
possible as well, but not
advised. The nylon spacers
between the board and
mounting plate will likely fall
down inside the enclosure
when removing and
remounting the transition
board assembly.
5) Lift up slightly, then to the left
to remove the transition
board and mounting plate
from the enclosure.