Service manual

4
6) Cut any plastic wire ties holding
the cable to the other cables, and
remove it from the enclosure.
7) Mount the new cable socket to the
enclosure rear wall with the existing
screws and nuts. Be sure to orient
the socket in the same direction as
the original.
8) Route the new cable up and over
the driver assembly area, and zip tie
it neatly to the other cables as
previously.
9) Insert the black and clear wires into
the green plug terminals, and
tighten the terminal screws.
10) Insert the green plug into the front cable socket, and connect the ground wire
terminal to the tab.
11) Plug the external motor cable back into the socket on the back panel of the
enclosure.