Service manual

3
4) Using a small flat-blade screwdriver,
loosen the terminal screws for the
small black and clear-insulation
wires on the green connector plug.
These are the top two wires which
lead to a different external socket
than the rest of the wires.
Remove the two wire terminals,
noting the location of each.
5) Follow the cable to the socket
mounted to the rear panel of
the enclosure, and remove the
four screws and locking nuts.
(1/4” nut driver and 1/16” Allen
wrench) Be careful not to drop
any of the nuts down into the
PC enclosure.