Service manual

1
Replacing or Upgrading RAM
The F-6100 computer comes with 32 Mb or RAM (Random Access Memory), consisting
of two, 16 Mb, 72-pin SIMM modules. One or both modules may be replaced if found to
be damaged or defective. RAM may be increased by changing to two 32 Mb or 64Mb
“DIMM” modules.
1) Shut down the F-6100 normally. Remove the lower electronics enclosure access
panel by removing the six screws with a 3/32” Allen wrench. The RAM modules are
located at the
upper right area
of the computer
board, as shown.
2) To remove a RAM module, pry outward on each of the retaining tabs with a
fingernail, as shown. The module will release upward slightly.
RAM Modules