Service manual

6
CD-ROM Drive
Verify that the “jumper” configuration on the rear of the new CD-ROM drive is set for the
“Slave” option. There will be a diagram on either the rear or top face of the drive
indicating each of the jumper options, usually: “CSEL”, “Slave”, or “Master”. In the CD-
ROM diagram below, the “Slave” setting is the center jumper configuration.
Perform Steps 1 – 5 as above. (A Philips screwdriver is most often used for CD drives)
Insert a Compact Disc into the new drive and verify proper operation.
CD-ROM Mode jumper diagram
CD-ROM jumpers on
rear of drive set to
“Slave” option