Service manual

5
No special computer setup
procedure is required for floppy
disc installation. If a warning
message during boot up is
shown “Floppy disc fail…”, turn
off power and re-check cable
connections to the rear of the
floppy drive.
When boot up is complete, insert
a floppy disc and Save to and
Open files from it to verify
operation.
Replace the 3 screws at the
bottom of the electronics
enclosure to mount the drive
housing. Replace the lower
access panel as well.
Remove Floppy drive power connector (hard drive cables
removed for ease of access
)
Remove mounting screws from each side Remove / Insert floppy drive