Service manual

Computer Disc Drive Replacement
All three disk drives (Hard disk drive,
3.5” Floppy drive, and CD-ROM
drive), in the F-6100 computer are
accessed by removing the lower
access panel on the front of the
electronics enclosure. Remove all six
screws with a 3/32” Allen wrench.
Turn off power to the system, and
unplug the power cord for safety.
Hard Disc Drive (part # 12-801)
1) Remove the three small Allen head screws from the bottom face of the electronics
enclosure. (3/32”) Slide the entire disc drive housing forward in the enclosure a few
inches; enough to permit access to the cable connectors at the rear of the hard drive
and the mounting
screws on each side.