Service manual

Re-installation Procedure

1. Remove the two front cover panels from the replacement Electronics enclosure.

2. Carefully lift the control enclosure onto the lower pulley block of the frame, and align the three

M8 bolt heads with the keyhole slots.

3. Slide the enclosure rearward onto the narrow portions of the keyhole slots, then tighten the

three bolts with the 5mm Allen wrench securely.

4. Continue the procedure by reversing the removal sequence above. (Cable connection

diagrams below). Do NOT replace the front cover panels until machine is fully powered up

and found to be functional.

5. Load the Setup file from the previous computer onto the replacement computer’s hard drive,

if it had been saved to a 3.5” floppy disc. Save it to the C:\Program Files\F-6100 directory,

and replace the existing file when prompted.

6. Replace the two front cover panels. Do not over-tighten the 12 button head 3/32” hex screws.

Pneumatic Outputs

Motor Cables

P/J206

F-6100 Cable Connections

P/J205

P/J203

P/J201

P/J207

P/J204

P/J202

(Home only)

Home & Limits

Power Supply

P/J208