Service manual

Remove the two front cover panels

from the control enclosure. Using a

3/32” hex (Allen) wrench, remove

the six button head screws from

each panel.

7. Using a 5mm Allen wrench, loosen,

but do NOT remove, the three M8

button head bolts on the right inside

panel which attach the enclosure to

the frame extrusion. Turn each bolt

~1 ½ turns CCW.

8. Carefully slide the enclosure forward to allow the

bolt heads to align with the enlarged portion of the

keyhole slots, and lift away from the frame

extrusion to remove the box. Use caution, as the

enclosure weight is approximately 55lbs. (25 kg.)

Replace the two front cover panels onto the

enclosure, and pack for shipment.

Loosen 3 bolts and slide forward to lift off frame

Slide forward, then left

to remove