Service manual

8) Insert the clear air hose into the

new flow control valve, and the

black hose into the quick

disconnect fitting. Make sure that

each hose is fully inserted by

tugging on it after pushing inward

completely.

9) Re-connect the main air hose to the machine. Make a test cut and check for

acceptable amount of over-cut. Open the adjusting knob (CCW), to lengthen the

Start of Cut, and close the valve (CW), to reduce the Start of Cut or slow down the

rate of blade plunge. Be sure to tighten the knurled silver lock ring once you have

achieved the desired plunge speed / over-cut.

See the Calibration section for more information on flow-control valve adjustment.