Service manual

4
c. Hold the knob still, and
turn the silver lock ring all
the way in (clockwise),
locking the adjusting knob
in place.
6) Screw the new flow control valve into
the hole in the cutting head nearest the
cutting board, where the small ¼”
brass fitting was mounted initially.
(Since this valve works with the
opposite air flow direction as the
original valve, it must be mounted into
the opposite side of the cutting head
air cylinder).
Use the 5/16” nut driver to tighten the
valve securely into the cutting head.
Turn the hose fitting portion of the
valve to the left in order to face it
toward the air hose. Use caution not to
over tighten the valve or hold the tool
at an angle that may cause the
threaded portion of the valve to
accidentally crack or shear off.
7) Insert the quick disconnect fitting into the
cutting head hole nearest you, where the
original flow control valve had been mounted.
Tighten this fitting with the 5/16” nut driver as
well.
D.