Service manual

10
7) Optional: Remove the glide pad by
removing the four mounting
screws with a 5/64” or 2mm Allen
wrench.
8) Using a good pair of tweezers or
needle-nose pliers, turn the tip of
the thumbscrew fragment
Clockwise to back it out. Do NOT
attempt to remove the four blade
slide assembly screws. Doing so
will cause the blade slide bearings
to fall out, requiring return to
FTCO for repair.
9) Turn the screw gradually with the
tweezers until there is enough to
grab onto at the broken part of the
screw. Then carefully grasp the
screw with pliers or tweezers and
back it out the rest of the way
Counter-clockwise.
Do Not remove the four blade slide assembly screws!!
Remove glide pad screws