Service manual

3) Using a small, flat blade

screwdriver, remove the

two mounting screws from

the body of the PC valve

assembly. Make sure that

you remove the screws on

the left side of the valve,

and not the smaller,

recessed screws on the

right side. (See photo)

4) Pull the valve firmly off the

manifold once the screws

have been removed. A small

rubber gasket may remain

stuck to either the valve

body or the manifold

surface. You will need this

gasket if the replacement PC

valve did not come with one

attached. Do not attempt to

use more than one gasket

when mounting the new PC

valve back on the manifold.

5) Align the new PC valve to the manifold and insert the mounting screws, making sure

that the sealing gasket is free of debris and is properly located. Tighten both screws

securely.