Service manual

10
3) Remove the two mounting
wood screws from the cylinder
flange with a Philips
screwdriver, and remove the
button clamp cylinder from the
board.
4) Insert the replacement clamp cylinder into the cutting board, and orient the holes in
the flange to align with the existing holes in the particle board so that the air fittings
on the cylinder are located most conveniently for re-insertion of the hoses. Tighten
the two wood screws securely, but do not over-tighten or you will strip the holes in
the board.
5) Re-connect the air hoses to the clamp cylinder fittings. Make sure that the black
hose(s) are connected to the fitting(s) closest to the cutting board.
6) Reconnect the main air hose to the pneumatics panel. Actuate the PC 1 valve button
several times, and check the new cylinder’s hose connections for any air leaks.