Service manual

3
downward firmly to connect, then pull upward to make sure that each hose is fully
inserted.
8) Re-connect the control cable plug into the top of the panel. Be sure to turn the
locking collar clockwise as far as it will go, until you feel a slight detent.
9) Plug the main air hose back onto the male fitting on the pneumatics panel. Verify
that the compressor is turned on, and that the three air gauges on the panel are set
to 50, 30, and 32 psi, reading left to right.
10) Make test cuts to confirm that the clamping system and cutting head are operating
normally.