Service manual

4) Trace the location of

the top edge of the

panel plate onto each

of the frame

extrusions with a

pencil. This will

assure that the

replacement panel is

located precisely on

the frame.

5) Remove the 2

mounting bolts from

the panel with a 5mm

Allen wrench. Take

care not to allow the

panel to slide

downward too much

as the bolts are

loosened. (You may

need assistance from

another person for

steps 5 and 6.)

6) Remove the panel, and place the new panel in position using the pencil lines traced

onto the frame extrusions. Also make sure that the T-nuts in the extrusion channels

are aligned with the holes in the pneumatics panel plate. You may slide them up or

down to re-position them if necessary. Insert the mounting bolts and tighten them

securely.

7) Re-connect the four small air hoses into the appropriate fittings on the top of the

panel. Both the hoses and fittings are numbered for reference. Push the hoses