Service manual

3
MS DOS Prompt Option
You may also run the Reset B utility through the MS DOS prompt, if all other attempts
have failed.
Exit the F-6100 program, and press the Emergency stop knob, as above.
Click Start > Programs > “MS DOS Prompt”. When the MS DOS window opens, type
the commands as shown below:
1) From C:\WINDOWS, type CD.. press
Enter.
2) From C:\> type CD MEI (space
between), then Enter.
3) From C:\MEI> type CD 25 press Enter.
4) From C:\MEI\25> type CD SETUP press
Enter key.
5) From C:\MEI\25\SETUP> type
CONFIG –B0X340 press Enter again.
6) The Reset B utility will then initiate, and
the screen will appear as below:
“Finished” indicates that diagnostic has run successfully