Service manual

10
14) Use a pry bar or other suitable tool to create proper tension on the belt, and tighten
the mounting bolts as you maintain tension. There should be no more than ¼” of belt
deflection when the motor mounting bolts have been tightened.
15) Mount the cutting head plate back onto the Y-axis bearing cart. Make sure that the
pencil mark you made previously is in the top position. Tighten all 4 flat head screws
securely with a 5mm Allen wrench.
16) Mount the cutting head back onto the head mounting plate, and tighten all 4
mounting bolts securely. (5/32” Allen wrench). Insert both pneumatic hoses fully in
the proper fittings, and connect both electrical connectors.
17) Connect the main air hose to the machine, and turn on the computer. Make a test
cut to verify normal operation of the machine.
18) Mount the cutting head guard plate and Y-axis motor housing back on to machine.
Belt Deflection, ¼” maximum